TDM OVER IP Device(IPCE
Circuit Simulator)
Product Introduction
As long as the IP address
of two terminals can recognize each other, then this device can transmit
E1 signal via IP network readezvous point and can achieve join
monolithically with existing TDM Terminal, Such as PSTN connection, ATM,
Frame relay, ISDN, concentrated user exchange and so on. Provides
various operation of TDM directly and don’t need change any Terminal.
Product Feature
●
Transmit frame
or unframed E1 signal via IP net, Filly compatible with G.703
●
High
transmission rate and low transmission delay
●
Clock revert
stably, small dithering and excursion
●
Possess QoS
guarantee, supports transmit with data at the same time, assure E1 data
prior transmission
●
Convenient to
use, don’t need complex setting
●
Transmission
package look for address base on IP address and can be configured and
revisable
●
Transmission
package base on IP data package, shield specific transmission medium,
not only can be used in Ethernet /Token-ring or other wired network, but
also can be used to increase point to point TDM of wireless LAN. Even
can be used in network which mix with wired and wireless
●
Developed a
echo counteract device to E1 that it can cancel echo of outside 128ms
for some IP transmission network delay is too large and echo problem in
voice communication
Setting and Diagnosis
●
IPCE provides
menu mode setting service, convenient to use
●
IPCE provides
long-distance login connector to set long-distance device via telnet
●
IPCE supports
dynamic upgrade, when download new software edition, the old software
will be save in backup section. so, if new software be damaged, system
can still use old software
●
System provides
various alarm: LOS, AIS, LOF and so on
●
IPCE provides
local startup auto-inspection, and the inspection result can be observe
via super terminal
●
IPCE
provides statistic of network affair: data package lose, data package
delay, data package wobble and so on.
Technologies reference
●
LAN interface:
Port standard: IEEE802.3、IEEE802.3U
Port type: RJ45
Port mode: Auto-adapt to
10/100M
Protocol: CSMA/CD
●
E1 interface:
Line code: HDB3
Bit rate: 2048KBIT/S±50ppm
Frame structure: ITU-G.704,
ITU-G.706
Impedance: 75ohm(unbalance)
or 120ohm(balance) optional
●
Power
Voltage：220V
AC or －48V
DC
Power consumption:
＜10W(equip
fully)
●
Working environment:
Operating temperature:
0℃~45℃
Environment humidity:
90%(non-condensing)
Dimension: 482mm×44mm×209mm |
